Ken Posted January 27, 2019 Share Posted January 27, 2019 The head doesn’t seem go fit right. There’s a gap between head and neck and the bumps on n the head assembly don’t fit well into the guide holes for them. anyone else have this issue and a solution? Thanks. Link to comment Share on other sites More sharing options...
Bombort Posted January 31, 2019 Share Posted January 31, 2019 Probably too late, but i had the same problem. My problem was, that when i was assembling the head, i did not enough pressure to the head. When i was pressing the head a little more, it snapped into the right position and the gap was gone. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.