This entry is of how I started to carve the area of my scenic board set in the realm of death.

I started with these two pieces of equipment that I got on Amazon, below, you can see my electric foam cutter and my bottle of “ Vallejo Water Texture”

Here is the scalpel that I used for more rough cuts

I started with this piece of insulation foam.  Then I did my first carving, as shown here.

Here is the rough start of the positioning of my pieces.

As you can see here I have made the terrain more rigid and natural rather than flat, sadly this took up a good 5 hours or so!

I hope you enjoyed this!

Next time will be quite short as I am attaching some boulders, hills and dead trees.